COMPONENTS
AC Source
Thyristor
Gate Pulse
Resistor
Inductor
Voltmeter
Ammeter
Ground
OBSERVATION TABLE
| S.No. | Vrms (V) |
Irms (A) |
Vavg (V) |
Iavg (A) |
|---|
8
9
VT
5
6
7
THY
14
15
IL
VINP
1
2
3
4
AC
10
GP
11
12
VGP
16
17
R
18
19
VLOAD
13
GND
20
21
L
WAVEFORM
- STEP 1: Drag and drop the components in the workspace to create the circuit.
- Nos of required components:
- AC Source – 1, Thyristor - 1, Gate Pulse - 1, Resistor - 1
- Inductor - 1, Ammeter - 1, Voltmeter – 4, Ground – 1
- STEP 2: Make the connections as per the instructions given below:
- (a) (01-05, 03-05, 08-05, 09-06)
- (b) (02-21, 04-21, 07-10, 10-11)
- (c) (12-13, 06-14, 15-16)
- (d) (15-18, 17-20, 19-21)
- Note: Click on the wire to delete the connection.
- STEP 3: Click on the CHECK button to check the connections.
- Note: Right click on the component to open the dialog box to edit the properties of the component.
- STEP 4: Input the values for all the required components (AC Source, Gate Pulse, Resistor and Inductor) and the waveform will get plot automatically.
- STEP 5: Now, Click on the ADD button to insert the reading into the observation table.
- STEP 6: Now, you can input different values as per your requirement to get the desired waveform.
- STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.
- STEP 8: Click on the PRINT button to take out the print of the webpage.
- STEP 9: Click on the RESET button to reload the webpage.
